Other measures
Specialized measurement solutions for unique industrial applications.
Other measures Products
4 products available in this category
T7M Series
T7M is an electronic multipoint temperature transmitter with a SMART-HART® electronic and a built-in multiplexer that can accept up to 15 resistance thermometers PT100 (3-wires) or 14 resistance thermometers plus 1 interface or level sensor. The multipoint solution offers great advantages for his mounting simplicity and for connection cables saving. Output is analog 4÷20mA for averaging temperature measurement or HART® protocol for single point’s values and average.
OMD (Oil Mist Detector) Series
OMD is an atmospheric oil mist detection instrument for marine and industrial applications, developed for installation in machinery room, pump room, etc. in commercial, naval, ro-ro ships as requested by the actual international IMO marine regulations (circ.1086). The OMD detector is an independent measuring and transmitting system with 4÷20mA+HART® and photorelays output, proportional to the density of oil mist in the sampled air. OMD oil mist measuring is based on the physical principle of optical scattering. Infrared light emitted from a LED is received from two photodiodes for measure and reference purpose; by the comparison between the photodiodes output, the presence of oil mist can be detected. The typical flammability level of the oil mist is 50mg/l; the alarm level is set to 2.5% of lower flammability level and is calibrated to 1.2mg/l.
HMI Series
The touch panel HMI device is used to monitor the variables detected by HART transmitters. The most typical application is the level monitoring of tanks for marine or industrial applications that require a dislocated control for their cisterns. The HMI devices are used for monitoring and alarms management using the HART® communication protocol. It is possible to connect to the system up to 30 HART® compatible  transmitters on two buses in multi-drop mode, while in mixed mode 30 HART® transmitters and 12 on/off switches (16 in the only On/Off version).
27M Series
27M series converters/transmitters measure and converts relative and differential pressures into an electrical signal both for standard values (3Ă·15 psi or 0.2Ă·1 bar) and not standard ones. The sensor is a Wheatstone bridge integrated on a chip. The direct conversion of the pressure into an electrical signal is achieved by a minute deflection of sensor diaphragm which changes the resistance of the bridge with the applied stress; changes in pressure cause a corresponding change in the transmitter output proportionally to the bridge unbalance.
Need technical assistance?
Our engineers can help you select the right other measures for your application.